7.1. General information about service of system of release
General information about service of system of release
|
|
You make survey or repair of system of release only when system absolutely cold. Working under the car, be convinced that it is reliably established. |
Muffler and pipes
If any parts are fixed incorrectly, then excess noise and vibration can be transferred to a body.
Regularly you examine system of release. Look for the damaged or curved parts, open seams, openings, weak connections, strong corrosion or other defects which allow the fulfilled gases to get into the car. Generally, worn-out components of system of release are not subject to satisfactory repair; they should be replaced.
If to connect components of system of release because of strong corrosion or a rust together, then can be required to cut off old components a hacksaw. Do not forget to use for protection of eyes against metal sawdust reliable points, and for protection of hands - gloves.
Some recommendations about repair of system of release are given below:
- At removal of components of system of release begin with a back of the car and move ahead.
- Apply a rust eliminator to simplification of an otvorachivaniye of nuts and bolts of system of release.
- At installation of components of system of release apply new laying, suspension brackets and collars.
- At assembly you apply an anticorrosive compound on carvings of all nuts and bolts of system of release.
- Make sure that between again established parts and all points of the bottom there is an additional gap to avoid an overheat of a floor and possible damage of rugs and isolation. Pay special attention to the catalytic converter and the filter. Also be convinced that the exhaust pipe will not make contact with parts of a suspension bracket and so on.