4a6fe675


5.5. Removal and installation of the distributor of ignition

TCI system

Removal

 PERFORMANCE ORDER

  1. Disconnect after careful marking from an ignition distributor cover high-voltage wires of the coil of ignition and spark plugs (watch Chapter Routine maintenance of the car).
  2. Remove a spark plug No. 1 (the next to an engine front).
  3. Manually turn the engine to the Top Dead Point (TDP) of a step of compression of the piston No. 1 (watch the Part the Repair work which is carried out without extraction of the engine from the car).
  4. Attentively note vacuum hoses if more than one approach the distributor of their ignition.
  5. Disconnect vacuum hoses.
  6. Disconnect from the distributor of a wire of primary chain of ignition.
  1. Note position of the runner in relation to the ignition distributor case (it is shown by an arrow). Also note position of the case of the distributor of ignition concerning the engine.
  1. Remove a fixing nut or a bolt and a bracket.
  2. Remove the ignition distributor.

Do not turn the engine at the removed ignition distributor.

Installation

Before installation of the distributor of ignition be convinced that the piston No. 1 still is in compression step VMT.

 PERFORMANCE ORDER

  1. Insert the ignition distributor into the engine, having placed an adjusting bracket over a fixing opening. Do not interfere at installation of the distributor of ignition with turn of an axis of the distributor.
  2. Establish a fixing nut or a bolt. Before tightening of a nut or bolt it is necessary to combine the tags which are previously applied on the distributor case, the runner and the engine.
  3. Establish an ignition distributor cover.
  4. Attach to the wire distributor.
  5. Attach high-voltage wires of spark plugs.
  6. Attach vacuum hoses according to marking.
  7. Check the ignition moment (watch the Partition Check of Functioning and Adjustment of the Moment of Ignition (TCI system)).

Motronic system

Removal

 PERFORMANCE ORDER

  1. Remove a cover of the distributor of ignition and uncover the distributor (watch Chapter Routine maintenance of the car).
  1. Small prutkovy key unscrew three screws of the runner.
  1. Remove the runner.

Installation

Installation back to removal.