4a6fe675


15.2. Removal and installation of the control unit of operating modes of a heater and conditioner of air

Removal

 PERFORMANCE ORDER

  1. Disconnect a negative wire of the battery.

If the radio receiver of your car is equipped with system of protection against theft, make sure that you gathered the correct code before a battery detachment.


If after connection of the battery of an inscription on an instrument guard appeared not in that language, address the Section System of protection of the audio system against theft and language of an instrument guard where the procedure of installation of the necessary language is described.

  1. Remove the central console (see the Head Kuzov).
  2. Remove the radio receiver (see the Head Sistem of onboard electric equipment), then remove handles from control levers a heater and the conditioner of air.
  3. Remove a finishing frame and take the control unit from the dashboard. It will allow you to disconnect wires of management from assembly of a control lever.
  4. Disconnect wires from the clips holding them on assembly of the lever, having marked them previously for the correct connection.
  5. Disconnect the electric socket from the control unit.
  6. Give screws of fastening of a frame to the control unit and remove the control unit.

Installation

You make installation upside-down.