4a6fe675


9.2.3. Adjustment of the drive of the lever of the selector

The car and reliably establish to Poddomkratta it on axial support. On some models, perhaps, it is necessary to remove system of release (see the Head the Power supply system) and a heat-resistant guard to get access to the lower end of the lever of the selector.

Transmission 3H 22

 PERFORMANCE ORDER

  1. Release a fixing clip (1) on a finger (2) rods of the selector.
  1. Pull out a finger and disconnect a selector rod from the lower end of the lever.
  2. Take away the selector lever on transmission back against the stop, then forward on two clicks. Now transmission is in situation "N" (Neutral).
  3. Working in interior of the car, install the selector lever in situation "N" (Neutral).
  4. Ask the assistant to advance the selector lever, having established it opposite to a stopper of neutral situation on the coulisse of the selector. Working under the car, turn a finger on a selector rod until it is not combined with an opening on the lower end of the lever of the selector. Truncate the drive, having turned a finger on one-two turns clockwise.
  5. Establish a selector rod finger. Make sure that the drive is adjusted correctly, having started the engine, having strong pressed a brake and having carried out the selector lever through all provisions.

Transmissions 4H 22

 PERFORMANCE ORDER

  1. In interior of the car install the selector lever in situation "P" (Parking).
  2. Weaken a nut of fastening of a cable to the selector lever on transmission (it is specified by an arrow).

The drive shown on a photo (for latest models), is typical; however on some old models the lever can be directed not down, and up and to use instead of a nut a kulisny design between a rod and the lever.

  1. Take away the selector lever on transmission forward (to the engine) and pull a selector cable rod back.
  2. Connect a cable rod to the selector lever on transmission and reliably tighten a nut.
  3. Make sure that the drive is adjusted correctly, having started the engine, having strong pressed a brake and having carried out the selector lever through all provisions.