- Before the procedure of adjustment described below check adjustment of a cable of an accelerator at completely open throttle, and if necessary adjust it (see the Head the Power supply system).
|
|
- At the released accelerator pedal by means of the measuring probe check distance between a cable stopper (it is specified by an arrow) and the end of the carving plug of a cable then compare result to the value specified in the Size table and adjusting data at the end of the Management.
|
|
|
- Weaken a lock nut of the switch of the device of the transfer of AT to the low gear located under an accelerator pedal, and screw in the switch as it is possible further.
|
- Squeeze out an accelerator pedal to situation when you feel its resistance, and hold it in this situation; now unscrew the switch so that it only concerned a pedal, and tighten a lock-nut.
- Check quality of adjustment, having squeezed out an accelerator pedal in situation kik-Down and having noticed the provision of a stopper of a cable (see item 2). Compare result of measurement to the size specified in the Size table and adjusting data at the end of the Management. If the cable does not manage to be adjusted up to the necessary size, double-check, and if necessary adjust an accelerator cable at completely open throttle. After the cable of an accelerator is adjusted, try to adjust a cable of the drive of a butterfly valve once again.
|
|
