11.1.6. Removal and installation of the pump of the amplifier of steering



  1. The car and reliably establish to Poddomkratta it on axial support. Remove the engine pallet.
  2. On the E28 models ("retro") discharge hydraulic system, having squeezed out a pedal of a brake about 20 times.
  3. Disconnect a hose of the returnable line and merge liquid from the tank in a pure container. Disconnect the inlet line from the pump.
  4. If you need to remove a pulley from the pump, pull a hand a driving belt of the pump and give nuts or bolts of a pulley.
  5. Release a bolt of a natyazhitel of a driving belt of the steering pump and take off a belt (see the Head Routine maintenance of the car).
  6. Give fixing bolts and remove the steering pump.
Typical fixing bolts of the steering pump are specified by shooters.



  1. You make installation upside-down. Reliably tighten nuts and bolts. Adjust a tension of a driving belt (see the Head Routine maintenance of the car).
  2. Add liquid in the tank to the necessary level (see the Head Routine maintenance of the car) and pump over system (see the Section Pumping of Hydraulic System of the Mechanism of Hydrostrengthening of a Wheel).