4a6fe675


10:11. Removal and installation of a casing of differential

Removal

 PERFORMANCE ORDER

  1. Back of the car and reliably establish to Poddomkratta it on axial support. Merge lubricant liquid of differential (see the Head Routine maintenance of the car).
  2. Disconnect the driveshaft from a gear wheel flange (see the Section Removal and installation of the driveshaft). Suspend the end of the driveshaft on a piece of a wire not to damage the central bearing.
  3. Otboltite the internal ends of power shafts from differential flanges (see the Section Removal and installation of power shafts). Suspend power shafts on pieces of a wire not to damage CV JOINTS.
  1. Disconnect wires from the speedometer sensor, give two fixing bolts of the sensor (one of them is specified by an arrow) and remove the sensor.
  1. Prop up differential a cart jack.
  1. Give two back fixing bolts (are specified by shooters) in the top part bearing the back bridge (the left side is shown)
  1. Give a forward fixing bolt of differential (it is specified by an arrow).
  1. Lower differential and take it from under the car.

Installation

 PERFORMANCE ORDER

  1. Place a differential casing into place on its support and spread bolts (do not tighten them until all are got), then reliably tighten fixture.
  2. You make the rest of the procedure of installation as it should be, the return to removal.