BMW:: 5th E28/E34 series:: Adjustment of a pedal of a brake

1. Cars of the BMW 5-brand of a series
2. Engine
3. Cooling system
4. Power supply system
5. System of ignition
6. Control systems of the engine and decrease in toxicity of the fulfilled gases
7. System of production of the fulfilled gases
8. Coupling
9. Manual Box of Gear Shifting (MBGS) and automatic transmission (AT)
10. Transmission line
11. Steering and suspension bracket
12. Brake system
- 12.1. General information
- 12.2. General information on the anti-blocking brake system
- 12.3. Replacement of blocks of disk brake mechanisms
- 12.4. Removal, capital repairs and installation of a support of the disk brake mechanism
- 12.5. Survey, removal and installation of a brake disk
- 12.6. Replacement of boots of drums of brake mechanisms
- 12.7. Removal and installation of the main brake cylinder
- 12.8. Check of a state, removal and installation of the vacuum amplifier of brakes
- 12.9. Description, removal and installation of the vacuum hydraulic booster of the brake system
- 12:10. Replacement of a cable (cables) of the drive of the parking brake
- 12:11. Adjustment of the parking brake
- 12:12. Check of a state, removal and installation of assembly of the parking brake
- 12:13. Adjustment of a pedal of a brake
- 12:14. Check and adjustment of the switch of a stoplight
- 12:15. Survey and replacement of brake lines and hoses of hydraulic system of brakes
- 12:16. Pumping of hydraulic system of brakes
- 12:17. Diagnostics of malfunctions of the brake system
13. Body
14. Control body sizes
15. Heater and conditioner of air
16. System of onboard electric equipment
17. Routine maintenance of the car
18. Size table and adjusting data
19. Schematic electric circuits
20. Governing bodies and methods of operation
21. System of onboard diagnostics - the principle of functioning and codes of malfunctions

12:13. Adjustment of a pedal of a brake

After replacement or removal of the main cylinder or the vacuum amplifier of brakes it is always necessary to regulate brake pedal height. At the same time it is also necessary to adjust and the switch of a stoplight (see the Section Check and adjustment of the switch of a stoplight).

Measure distance between bottom edge of a pedal of a brake (i.e. edge which is further everything from a partition) and a partition And, and compare this size to that that it is provided in the Size table and adjusting data at the end of the Management. If these sizes do not coincide, release a lock-nut (1) on a pusher and turn a pusher, holding at the same time a fork (3) in an immovability until they do not coincide.

On models with left-side management adjustment is made on the left side of a cross shaft after removal of a ware box, but the distance nevertheless is measured from a pedal.