4a6fe675


4.17. Functioning check, removal and installation of the case of a throttle

Check

 PERFORMANCE ORDER

  1. Disconnect an inlet air duct (look the Section Removal and installation of the air cleaner) from the throttle case and take him aside.
  2. Watch the throttle valve when the assistant presses an accelerator pedal. Check that the throttle valve smoothly moved from a closed position (idling) to completely open (complete revolutions).
  3. If the valve of a throttle does not work correctly, replace throttle case knot.

Before this procedure wait for full cooling of the engine.


If the radio receiver on your car is equipped with system of protection against stealing, then before shutdown of the rechargeable battery be convinced that the correct code of activization is known. Before a detachment of a wire apply for information in the Section System of Protection of the Audio System from theft and language of an instrument guard.


If after shutdown of the battery on the display of the dashboard the message in other language appears, then for the procedure of installation of language address the Section System of Protection of the Audio System from theft and language of an instrument guard.

Removal and installation

 PERFORMANCE ORDER

  1. Disconnect a negative wire of the rechargeable battery.
  2. Disconnect an inlet air duct from the throttle case and take him aside.
  3. Disconnect an accelerator cable from the throttle case (look the Section Check, adjustment and replacement of a cable of an accelerator).
  4. If it is applied, then disconnect a cable of a tempostat.
  5. Distinctly mark all electric sockets (the sensor of provision of a throttle, an injector of cold start-up, the air supply stabilizer idling and others), then disconnect them.
  6. Distinctly mark all vacuum hoses, then disconnect them.
  7. For removal of any residual pressure in the cooling system turn off a cover of a radiator or a broad tank, then again screw it. Block clips cooling hoses, then weaken collars of hoses and disconnect hoses. Be ready to an insignificant effluence of a cooler.
  1. Turn off nuts (above) and bolts (in the bottom of) fastening of the case of a throttle and disconnect the throttle case from a flange of the inlet pipeline.
  1. Close an opening of a flange of the inlet pipeline pure fabric that at the removed case of a throttle to prevent hit of dirt and dust.
  2. Installation back to removal. Tighten nuts of fastening of the case of a throttle with specified in the Size table and adjusting data at the end of the Management of effort and after that adjust an accelerator cable (look the Section Check, adjustment and replacement of a cable of an accelerator).