- Remove a flywheel or a driving disk (see the Section Removal and installation of a flywheel / a driving disk).
|
|
- Give bolts and/or nuts of fastening of the holder of an epiploon to the block of cylinders. Do not forget to give two bolts (in the bottom of) fastening of a back part of the pallet of a case to the lower part of the holder of an epiploon.
|
- Carry out by a thin sharp knife between laying of the pallet of a case and a forward cover, separating thus laying from a cover. Be very careful not to damage and to soil laying that you could use it again then.
- Destroy laying sealant between the holder and the block of cylinders, having tapped a cover the hammer with rubber brisk or the ordinary hammer, having put wooden whetstone. Do not push anything between a cover and the block not to damage the surface of laying.
- Using a scraper, remove all traces of material of old laying from the interfaced surfaces of the holder and the block of cylinders. On sale are available, and there can be useful, special solvents for removal of laying. After full removal of material of laying of a surface of laying it is possible to degrease, having wiped them with the rag moistened in suitable solvent.
|
|
Be extremely careful not to damage and to scratch soft aluminum surfaces. Besides, try not to damage and not to soil laying of the pallet of a case. |
|
|
- Prop up the holder two wooden whetstones and beat out an epiploon from the back party by means of the hammer and the screw-driver.
|
- Be careful, trying not to damage in the course of work an opening for an epiploon.
|
|
- Cover the outer diameter and sponges of a new epiploon with universal lubricant and establish an epiploon in the holder by means of the hammer and wooden whetstone.
|
- Apply a thin film of sealant like RTV on the surface of laying of the pallet of a case interfaced to the holder of an epiploon. You apply more sealant on edges where laying adjoins to the block of cylinders.
|
|
If laying of the pallet of a case is damaged, then instead of full replacement of laying you can try to cut off its forward part where it adjoins to the block of cylinders, then to cut off a forward part of new laying that it was just the same size. Cover the internal surface of the pallet with a piece of rags, then clean off all traces of material of old laying from the interfaced surfaces. Attach a piece of new laying to the pallet by means of special adhesive substance, then apply RTV sealant as it is described at the beginning of this paragraph. |
- Grease both parties of new laying with RTV sealant, then connect laying to the holder of an epiploon. Establish the holder on a back part of the engine, then spread bolts and tighten them with the required effort. Tighten bolts one by one according to the crosswise scheme to make it evenly.
|
|
At first tighten bolts of fastening of the holder to the block of cylinders, then bolts of fastening of the pallet of a case to a cover. If laying acts over connection of a cover with the block or forms folds in connection of a cover with the pallet, cut it that it stood correctly. |
|
|
After putting RTV sealant assembly has to be finished within 10 minutes to be in time before sealant hardening. |
- Establish a flywheel / a driving disk (see the Section Removal and installation of a flywheel / a driving disk).
- Establish transmission (for cars with manual transmission see the Head the Manual Box of Gear Shifting (MBGS); for cars with automatic transmission see the Head the Automatic Transmission (AT)).
|
|
