4a6fe675


2.1.8. Removal and installation of covers of a distributive belt

This procedure belongs only to M20 and M40 engines.


If the radio receiver of your car is equipped with system of protection against theft, make sure that you gathered the correct code before a battery detachment.


If after connection of the battery of an inscription on an instrument guard appeared not in that language, address the Section System of Protection of the Audio System from theft and language of an instrument guard where the procedure of installation of the necessary language is described.


 PERFORMANCE ORDER

  1.  Disconnect a negative wire of the battery.
  2. Remove the coupling of the drive and a casing of the fan (see the Head the Cooling system).
  3. On the M20 engine remove a radiator (see the Head the Cooling system).
  4. Remove a pulley of a driving belt of the fan.
  5. Disconnect conducting of the sensor of the standard if it is provided which passes through a forward part of a cover of a distributive belt, and take him aside.
  1. If the cover of the distributor of ignition is established directly on the top cover of a distributive belt, uncover the distributor, the runner and the black plastic cover located under the runner.
 
 
  1. Remove a pulley of a driving belt and a damper of the lower fan. Hold the central bolt of a pulley of the crankshaft during weakening of bolts of an external pulley / damper.
  1. Give bolts/nut of fastening of covers of a distributive belt to the engine.
  1. Remove at first the top cover, then lower.

On the top cover there are two plugs for combination of provisions of the top bolt. At assembly make sure that they on the place.


1 — the Top cover of a distributive belt
2 — the Lower cover of a distributive belt
 
 
  1.  You make installation upside-down. Reliably tighten bolts of covers.