- Disconnect a negative wire of the battery.
- On models where the air cleaner is from the same party of the engine, as a final collector, remove assembly of a casing of the air cleaner and/or measuring instrument of an air stream to provide enough place for work (see the Head the Power supply system, if necessary).
|
|
For convenience of work take also the windshield washer tank from the right part of a motive compartment. |
- Disconnect VV of a wire and remove conducting of spark plugs aside (see the Head Routine maintenance of the car).
- Mark and then disconnect all wires, hoses, nipple connections, etc. which prevent work. Do not forget to disconnect the oxygen sensor where it is provided.
|
|
- The car and reliably establish to Poddomkratta it on axial support. Working under the car, disconnect a reception pipe from a collector. For simplification of work use the getting oil for fixture lubricant.
|
|
|
- Remove axial support and lower the car. Moving from the ends of a collector to its center, release gradually fixing nuts so that they could be removed. Here again the getting oil can help.
|
|
|
- Pull together a collector from a head, then remove old laying.
|
|
|
Be extremely careful not to damage the oxygen sensor where it is provided. |
- Clear the surfaces of interface of a head and a collector and make sure that the carving on screws of adjustment of gaps of valves of a final collector is not damaged.
- Check whether there is no corrosion, deformations, cracks or other damages of a collector. If necessary repair or replace a collector.
- At installation of a collector use new laying. Tighten nuts of fastening of a collector to a head gradually, beginning from the center and moving ahead to edges, trying to obtain the required effort. Tighten also nuts of fastening of a reception pipe to a collector.
- You make the rest of the procedure of installation as it should be, the return to removal.
|
|
Пальто больших размеров оптом в Москве