BMW:: 5th E28/E34 series:: Rotation of wheels

1. Cars of the BMW 5-brand of a series
2. Engine
3. Cooling system
4. Power supply system
5. System of ignition
6. Control systems of the engine and decrease in toxicity of the fulfilled gases
7. System of production of the fulfilled gases
8. Coupling
9. Manual Box of Gear Shifting (MBGS) and automatic transmission (AT)
10. Transmission line
11. Steering and suspension bracket
12. Brake system
13. Body
14. Control body sizes
15. Heater and conditioner of air
16. System of onboard electric equipment
17. Routine maintenance of the car
- 17.1. Schedule of routine maintenance
- 17.2. Introduction
- 17.3. Current leaving
- 17.4. General information on control
- 17.5. Check of levels of liquids
- 17.6. Check of a condition of tires and pressure in them
- 17.7. Replacement of motive oil and oil filter
- 17.8. Check of level of liquid of system of hydrostrengthening of a wheel
- 17.9. Check of level of lubricant liquid of automatic transmission
- 17:10. Rotation of wheels
- 17:11. Check of a state and replacement of hoses of a motive compartment
- 17:12. Check of a state, adjustment of a tension and replacement of driving belts
- 17:13. Check and adjustment of turns of idling of the engine and SO level
- 17:14. Check of a condition of the battery, care of it and charging
- 17:15. Check and replacement of spark plugs
- 17:16. Check and replacement of candle VV of wires, cover and runner of the distributor
- 17:17. Check of level of oil in a manual box of gear shifting
- 17:18. Check of level of lubricant liquid of differential
- 17:19. Check and adjustment of gaps of valves
- 17:20. Check and lubricant of draft of the drive of a butterfly valve
- 17:21. Replacement of the air filter
- 17:22. Check of fuel system
- 17:23. Check of functioning of the cooling system
- 17:24. Check of a condition of system of production of the fulfilled gases
- 17:25. Check of a condition of components of a suspension bracket and steering
- 17:26. Check of a condition of protective covers of power shafts
- 17:27. Check of the brake system
- 17:28. Check of a state and replacement of brushes of screen wipers
- 17:29. Replacement of transmission liquid and AT filter
- 17:30. Discharge, washing and filling of the cooling system
- 17:31. Replacement of the fuel filter
- 17:32. Replacement of gearbox oil of manual transmission
- 17:33. Replacement of lubricant liquid of differential
- 17:34. Check of functioning of system of catching of vapors of gasoline (EVAP)
- 17:35. Control of an alarm lamp of the notification about approach of the term of planned maintenance (TPM)
- 17:36. Replacement of a distributive belt of the engine
18. Size table and adjusting data
19. Schematic electric circuits
20. Governing bodies and methods of operation
21. System of onboard diagnostics - the principle of functioning and codes of malfunctions

17:10. Rotation of wheels

Two times a year or each 10 000 km of a run (that will come earlier)

Rotation can be made or through the intervals specified in the Head Routine maintenance of the car, or at emergence of signs of uneven wear of protectors. However you remember that in case of successful rotation of all four wheels you eventually should replace all tires at the same time.

As holding this procedure demands a car raising above the ground and removals of wheels, check at the same time and operation of brake mechanisms (see the Section Check of the Brake System).

Even if you are not going to make rotation, at least check reliability of an inhaling of bolts of fastening of wheels.

It is recommended to make rotation according to the special scheme so that the direction of their rotation was same.

PERFORMANCE ORDER

Address information in Poddomkrachivaniye's Section, towage and change of wheels for the correct raising of the car and change of a wheel.
The car should be lifted the winch or to install it on axial support that all four wheels were to lift above the ground. Make sure that the car is reliably fixed!
After the end of a procedure of rotation check and adjust pressure in tires and do not forget to check reliability of an inhaling of bolts of fastening of wheels.