4a6fe675


16:14. Removal and installation of a starter

If the starter is faulty, then it should be replaced or sent for repair to the auto electrician. Capital repairs of a starter in house conditions are inexpedient even if there are spare parts. However, the traction relay can be replaced (look the Section Removal and installation of the traction relay).

Removal

If the radio receiver on your car is equipped with system of protection against stealing, before shutdown of the rechargeable battery be convinced that the correct code of activization is known. Before a detachment of a wire address the Section System of Protection of the Audio System from theft and language of an instrument guard.


If after connection of the battery on the display of the dashboard the message in other language appears, for the procedure of installation of language address the Section System of Protection of the Audio System from theft and language of an instrument guard.


 PERFORMANCE ORDER

  1. Disconnect a negative wire of the rechargeable battery.
  2. Lift the car and install it on props.
  3. Mark the wires attached to plugs of a starter and the traction relay, then disconnect wires.

On some models it is necessary to remove the air cleaner (watch Chapter the Power supply system), a broad tank of the cooling system (watch Chapter the Cooling system) and heater hoses to provide access to the top part of a starter. To avoid mistakes at the subsequent accession carefully mark all hoses and components which are removed in a motive compartment.


  1. Working under the car, remove the lower bolt and a nut of fastening of a starter (are shown by shooters) and remove a starter.
Removal of a starter from the M40 engine.

Installation

Installation back to removal.