4a6fe675


16:27. Removal and installation of the motor of a screen wiper of windshield / glass of a door of a back

If the radio receiver on your car is equipped with system of protection against theft, make sure that you gathered the correct code before disconnecting a battery wire. Apply for information in the Section System of Protection of the Audio System from theft and language of an instrument guard before a wire detachment.


If after accession of a wire on your instrument guard there were inscriptions not in that language which is necessary to you, address the Section System of Protection of the Audio System from theft and language of an instrument guard where the procedure of installation of the necessary language is described.

Disconnect a negative wire of the battery.

Windshield screen wiper motor

 PERFORMANCE ORDER

  1. Remove caps and give nuts.
  1. After return of a nut use a magnet to remove a metal washer, then remove screen wiper levers.
  1. Hook fixing clips and remove a fairing lattice to get access to assembly of a screen wiper.
  2. Give screws or nuts and uncover a screen wiper, located on a partition of a motive compartment.
  3. Disconnect the electric socket and remove draft of a screen wiper.
  4. Mark the provision of a shaft of a screen wiper concerning draft. Remove draft of a screen wiper from a motor shaft, having accurately hooked it the screw-driver.
  5. Give three fixing bolts and remove the screen wiper motor from the car.
  6. You make installation upside-down. At installation of the motor if it is necessary, connect the socket and turn on the motor to establish it in neutral situation (screen wipers in non-working situation).

Back door screen wiper motor

 PERFORMANCE ORDER

  1. Discover back glass of a door of a back.
  2. Remove the panel (panels) of a covering, then disconnect a tube of a washer and the socket of conducting.
  1. Give fixing nuts and remove the screen wiper motor.
  1. Brushes and the rotary mechanism of a screen wiper can be removed from back glass if necessary after removal of panels of a covering.
  1. You make installation upside-down. At installation of the motor if it is necessary, connect the socket and turn on the motor to establish it in neutral situation (screen wipers in non-working situation).