4a6fe675


16:17. Removal and installation of switches on a steering column

Some of latest models are equipped with a pneumopillow, or the Auxiliary Security system (SRS). To avoid possible damages of this system, the producer recommends with a pneumopillow to provide the procedure of competence of dealer office of service or auto repair shop described below since she demands use of the special equipment and technologies for models. There is also a danger of injuries in case the mechanism of the airbag incidentally works.


If the radio receiver on your car is equipped with system of protection against theft, make sure that you gathered the correct code before disconnecting a battery wire. Apply for information in the Section System of Protection of the Audio System from theft and language of an instrument guard before a wire detachment.


If after accession of a wire on your instrument guard there were inscriptions not in that language which is necessary to you, address the Section System of Protection of the Audio System from theft and language of an instrument guard where the procedure of installation of the necessary language is described.

Disconnect a negative wire of the battery, remove a steering wheel (see the Head Steering) and casings of a steering column (see the Head Kuzov).

Switch of the index of turn / head headlights

 PERFORMANCE ORDER

  1. Where it is necessary, give screws of fastening of the switch. Squeeze uvulas and pull out the switch from fastening of a steering column.
  1. Go down on switch wires to a steering column to the electric socket and disconnect wires.
  1. You make installation upside-down.

Screen wiper/washer switch

 PERFORMANCE ORDER

  1. Where it is necessary, give screws of fastening of the switch.
  1. Squeeze out a fixing clip and remove the switch from fastening of a steering column. Go down on switch wires to the socket and disconnect wires.
  1. You make installation upside-down.

Switch of a control system of speed

 PERFORMANCE ORDER

  1. Remove the screen wiper/washer switch.
  1. Where it is necessary, give the screw of fastening of the switch. Squeeze fixing uvulas and pull out the switch from fastening.
  1. Disconnect the electric socket of the switch from conducting in the basis of a steering column.
  2. You make installation upside-down.