4a6fe675


16.9. Removal and installation of the generator

If the radio receiver on your car is equipped with system of protection against stealing, before shutdown of the rechargeable battery be convinced that the correct code of activization is known. Before a detachment of a wire apply for information to the Section System of Protection of the Audio System from theft and language of an instrument guard.


If after connection of the battery on a disk of the dashboard the message in other language appears, for the procedure of installation of language address the Section System of Protection of the Audio System from theft and language of an instrument guard.

Removal

 PERFORMANCE ORDER

  1. Disconnect a negative wire of the rechargeable battery.
  1. Disconnect electric sockets from the generator, having remembered their arrangement. Depending on the number of the equipment on the car sometimes can be simpler to remove at first the generator from arms, and then, having turned aside, to provide access to the sockets (are shown by shooters) located on a back wall of the generator.

On some models for receiving access to the generator can be required to remove the air cleaner and the measuring instrument of a stream of air.

  1. Weaken adjusting and fixing bolts of the generator and take off a driving belt (watch Chapter Routine maintenance of the car).
  2. Remove adjusting and fixing bolts and separate the generator from the engine.

Installation

If replacement of the generator is made, then, getting new or restored, take with yourself the former generator. Make sure that the new generator is identical to old. Pay attention to contacts - them has to be as much, they have to have the same sockets and an arrangement, as on the former generator. At last, pay attention to identification numbers - they are shtampovana on the case or are printed on the label fixed on the case. Make sure that on both generators of number identical.

Many new generators are not completed with a pulley therefore can be required to rearrange a pulley from the former generator on new.

 PERFORMANCE ORDER

  1. Installation back to removal.
  2. After installation of the generator pull a driving belt (watch Chapter Routine maintenance of the car). Check charge tension to be convinced of the correct operation of the generator (watch the Section Check of System of a Charge).