16:18. Removal and installation of the lock of ignition

Some of latest models are equipped with a pneumopillow, or the Auxiliary Security system (SRS). To avoid possible damages of this system, the producer recommends with a pneumopillow to provide the procedure of competence of dealer office of service or auto repair shop described below since she demands use of the special equipment and technologies for models. There is also a danger of injuries in case the mechanism of the airbag incidentally works.

If the radio receiver on your car is equipped with system of protection against theft, make sure that you gathered the correct code before disconnecting a battery wire. Apply for information in Razdelesistem of protection of the audio system against theft and language of an instrument guard before a wire detachment.

If after accession of a wire on your instrument guard there were inscriptions not in that language which is necessary to you, address the Section System of Protection of the Audio System from theft and language of an instrument guard where the procedure of installation of the necessary language is described.



  1. Disconnect a negative wire of the battery.
  2. Remove a steering wheel (see the Head Steering).
  3. Remove casings of a steering column (see the Head Kuzov).
  4. Where it is necessary, remove the switch of indexes of turn / head headlights (see the Section Removal and installation of switches on a steering column).
  1. Release clips, having inserted the small screw-driver into cavities on both sides of the ignition lock during extraction of the lock.
  1. Disconnect conducting of the lock of ignition from the socket in the basis of a steering column and remove the lock.


You make installation upside-down.