4a6fe675


16:19. Removal and installation of the radio receiver

If the radio receiver on your car is equipped with system of protection against theft, make sure that you gathered the correct code before disconnecting a battery wire. Apply for information in the Section System of Protection of the Audio System from theft and language of an instrument guard before a wire detachment.


If after accession of a wire on your instrument guard there were inscriptions not in that language which is necessary to you, address the Section System of Protection of the Audio System from theft and language of an instrument guard where the procedure of installation of the necessary language is described.

Removal

 PERFORMANCE ORDER

  1. Disconnect a negative wire of the battery.
  2. On the majority of models radio receivers are kept on the place by internal clips which are usually located on the parties or in corners of the front panel of the block. Removal demands the special tool which is inserted into openings to release clips and to have an opportunity to take the radio receiver. Such tools can be manufactured of a thick wire or to get in dealer office of service or from the specialist in the audio equipment of cars. On radio receivers with system of protection against theft clips are moved and move forward by means of internal screws that demands use of other tool. Insert the tool into openings and release clips, then take the radio receiver from the dashboard. Disconnect from it conducting and remove it.
  3. On some models the radio receiver is kept on the place by the screws located under the front panel. Handles of control should be removed before removal of the front panel.

Installation

You make installation upside-down.