4a6fe675


16:23. Replacement of lamps in head headlights

If the radio receiver on your car is equipped with system of protection against theft, make sure that you gathered the correct code before disconnecting a battery wire. Apply for information in the Section System of Protection of the Audio System from theft and language of an instrument guard before a wire detachment.


If after accession of a wire on your instrument guard there were inscriptions not in that language which is necessary to you, address the Section System of Protection of the Audio System from theft and language of an instrument guard where the procedure of installation of the necessary language is described.

Disconnect a negative wire of the battery.

The non-demountable (pressurized) lamps

 PERFORMANCE ORDER

  1. Remove a front grille (see the Head Kuzov).
  2. Give screws of fastening of a head headlight, trying not to damage adjusting screws.
  3. Remove the holder and push out a headlight outside so that it was possible to separate the socket.
  4. Remove a head headlight.
  5. For installation of a head headlight connect the socket, establish a headlight into place and insert fixing screws. Reliably tighten screws.
  6. Establish a front grille. Connect a negative wire of the battery.

Galogenovy lamps

The lamps filled with halogen are under pressure and can scatter into smithereens. If to scratch their surface or to drop. Put on goggles and handle with these lamps very with care, whenever possible taking them for a socle. Do not touch a surface of lamps fingers since fat from your skin can serve as the reason of their overheat and premature failure.


If all of you touched a lamp surface hands, wipe it with methyl alcohol.


 PERFORMANCE ORDER

  1. Remove an external cover of a headlight from the back party of assembly.
  1. Unscrew an internal cover from a back part of a headlight.
  1. Disconnect a wire from a back part of a lamp of a head headlight.
  1. Lower clips and take a lamp from the block of a head headlight. Do not touch a lamp surface fingers.
  1. Establish a new lamp as it should be, the return to removal. Make sure that clips hold a lamp.
  2. Connect a negative wire of the battery.